Diagnostic group

Material setup

Use these when one material, brand, color, or spool behaves differently from your known-good baseline.

8 diagnostic pages First test Run the recommended proof print with the same spool before changing multiple material values. Stop after one useful signal

Start here

Open the page that matches your evidence most closely.

Search all diagnostics

Material setup PETG Filament Settings for Stringing, First Layer, and Warping Use the manufacturer or slicer PETG range, then print a small temperature test with the actual spool. Material setup PLA Filament Settings Extrude into free air, then print the single-wall flow box. Material setup ABS Filament Settings Wash the plate and run the corner coupon. Material setup ASA Filament Settings Wash the plate and run the corner coupon.

PETG, textured PEI, direct drive and Bowden printers

PETG Filament Settings for Stringing, First Layer, and Warping

Fix PETG stringing, poor first layer adhesion, warping, weak layers, and PEI release problems with symptom-first PETG settings for OrcaSlicer, Bambu Studio, direct drive, and Bowden printers.

Run two-tower or temp test with same spool. PLA, PLA+, silk PLA, FDM slicers

PLA Filament Settings

PLA Filament Settings: tune spool condition, temperature, cooling, bed surface, and verification prints for a repeatable FDM material profile.

Extrude into free air, then print the single-wall flow box. ABS, enclosed FDM printers, PEI surfaces

ABS Filament Settings

ABS Filament Settings: tune spool condition, temperature, cooling, bed surface, and verification prints for a repeatable FDM material profile.

Wash the plate and run the corner coupon. ASA, enclosed printers, outdoor parts

ASA Filament Settings

ASA Filament Settings: tune spool condition, temperature, cooling, bed surface, and verification prints for a repeatable FDM material profile.

Wash the plate and run the corner coupon. PLA-CF, PETG-CF, PA-CF, hardened steel nozzles

Carbon Fiber Filament Nozzle Guide

Carbon Fiber Filament Nozzle Guide: tune spool condition, temperature, cooling, bed surface, and verification prints for a repeatable FDM material profile.

Extrude into free air, then print the single-wall flow box. Nylon, PA, PA-CF, hardened nozzles, dry boxes

Nylon Filament Settings

Nylon Filament Settings: tune spool condition, temperature, cooling, bed surface, and verification prints for a repeatable FDM material profile.

Run the five-patch first-layer test after washing the plate. TPU, TPE, direct drive printers, Bowden caveats

TPU Filament Settings

TPU Filament Settings: tune spool condition, temperature, cooling, bed surface, and verification prints for a repeatable FDM material profile.

Print the two-tower test and lower temperature 5 C. Silk PLA, decorative prints, FDM slicers

Silk PLA Settings

Silk PLA Settings: tune spool condition, temperature, cooling, bed surface, and verification prints for a repeatable FDM material profile.

Force seam to one corner and print the seam tower.